Epson Apex 80 User Manual page 52

To see program 1 produce the character in Figure 5-3, run the
program and follow these instructions:
1. When the screen message asks what rows have dots in column 1,
press
Enter
2. For column 2 (the vertical line) press 7,
to indicate that you want dots in rows 7 and 5. Then press
alone to indicate that no more dots go in column 2.
3. For column 3 press 8, 6, 4, and 2, and
Press
Enter
4. For column 4 press
that you know to press
time to end the entries for each column.)
5. For column 5 enter 6, 4, 3, 2, and 1.
6. For column 6 press
7. For column 7 enter 8, 6, 4, and 2.
8. For column 8 enter 7 and 5.
9. For column 9 press
Now wait a moment for your computer to calculate the dot patterns
and your LX-800 to print the new character in two different typestyles.
Your printout also gives you nine numbers, which you use in the next
program. You should get the printout you see below:
When you get to this point with a character of your own, you see
how it looks. If you want to make any changes, move the dots as
needed and re-run the program.
If you want to put dots in the bottom row, change the number in
line 190 from 128 to 0. Then the usable rows are those shown in Figure
below.
5-4
User-defined Characters
to indicate that no dots go in that column.
to finish with column 3 and go on to column 4.
only (The. rest of the directions assume
Enter
Enter
only.
Enter
only.
Enter
Enter,
Enter
after each number and one extra
5, and
Enter
Enter
after each of them.
again
5.5