Installing The Color Ribbon - Epson ActionPrinter 3260 User Manual

Remove the connector cover on the printer. Next, insert the
motor unit plug into the connector on the printer, as
shown below.
Attach the ribbon cartridge to the bracket. Next, remove the
packing tape.
Make sure the pins under the ribbon cartridge are placed
correctly inside of the bracket as shown below.
Move the print head to the middle of the printer and move
the sliding part of the ribbon to the middle of the ribbon
cartridge.
24-Pin Printers
6. Turn the ribbon-tightening knob in the direction of the
arrow to remove any slack in the ribbon.

Installing the Color Ribbon

The optional color upgrade kit must be installed before you
install the color ribbon.
Insert the ribbon cartridge (installed in the bracket) into
the printer as shown; then press both sides of the
cartridge firmly to fit the posts into the slots.
Turn the ribbon-tightening knob to ease the ribbon into
place. Make sure it is not twisted or creased.
Replace the printer cover by inserting its tabs into the holes
on the printer as shown below; then close the cover.
1/94
ActionPrinter 3260
AP-3260-13