Epson ActionLaser 1000 Installation Manual
Connect your macintosh to epson laser printers
Hide thumbs
Also See for ActionLaser 1000:
- User manual (70 pages) ,
- Setup manual (18 pages) ,
- Paper and paper delivery (11 pages)
Related Manuals for Epson ActionLaser 1000
Summary of Contents for Epson ActionLaser 1000
- Page 1 ® EPSON Connect Your Macintosh Computer ® to Epson Laser Printers Installation Guide for N ActionLaser™ 1000 N ActionLaser 1500 EPL-8000 CPD-1310...
-
Page 2: What You Need For Installation
Epson Talk Connect Your Macintosh Epson Talk allows you to use an Epson printer with your Macintosh computer. Use this Installation Guide to install Epson Talk quickly. If you require further details, please read the manuals enclosed, C823121 and along with your printer manual. -
Page 3: Installing The Interface Card
Installing the Interface Card 1. Make sure that both the printer and computer are turned off and that all power and interface cables are removed from the printer. Caution: Avoid touching the printer circuits or card circuit board contacts. Otherwise, you may damage them. - Page 4 (Do not use the serial port.) Then plug the other end of the cable into your computer. 7. Plug the power cord into your printer and an electrical outlet. Installing the PostScript Card Caution: Cl Do not insert the card while the printer is turned on.
- Page 5 The READY message may not show O PS (indicating the optional interface and PostScript) until after yourfirst print job is sent from your computer to the printer each time you turn on your printer. 10. Make sure that AppleTalk is active in the Chooser under the...
- Page 6 Note: you have an Epson EPL-8000 printer, you must have aj%mware version 22.48 or later to use Epson Talk. To find out your printer’s firmware version, print a status sheet as described in your printer manual. If you do not have the above firmware version, please call the Epson Connection at (800) 922-8911.
- Page 7 Note: The READY message may not show O PS (indicating the optional interface and is sent from your computer to the printer each time you turn on your printer. 14. Make sure that AppleTalk is active in the Chooser under the Apple menu on your Macintosh.