Assembly Instructions - Kobalt 3DPCWB2013 Assembly Instructions Manual

ASSEMBLY INSTRUCTIONS

Important: Do not over-tighten the screws as this may result in stripping them. After the workbench is
completely assembled, fully tighten each screw.
1. Attach the left rear leg (1L) and the left front leg (2L)
to the side frame (4) using screws (AA). On the side
frame (4), ensure the edge with the hole is facing up.
Hardware Used
M6x10 mm
AA
Screw
2. Attach the left side panel (3) using screws (AA).
Hardware Used
M6x10 mm
AA
Screw
1
x 4
AA
2
AA
x 4
5
1L
4
1L
3 3
2L
2L
2L