Assembly Instructions - Kobalt 10011 Manual

ASSEMBLY INSTRUCTIONS

1. Attach the cabinet handle (C) to the
tool chest (A) using M6 x 20 mm bolts
(AA) and tighten with supplied 10mm
wrench.
Note: The cabinet handle (C) can be
attached to either side of the tool chest (A),
but must match the end where the swivel
casters with brake (D) will be installed. The
holes in tool chest (A) are tapped and do
not require nuts.
Hardware Used
AA
M6 x 20 mm Bolt
2. Attach the cord storage brackets (B) to
the tool chest (A) holes with two
M6 x 20 mm bolts (AA) per bracket,
and tighten with supplied 10mm
wrench.
Note: Orient the brackets with one pointed left
and the other pointed right so that the power
outlet cord can be wrapped around the
brackets for storage.
Hardware Used
AA
M6 x 20 mm Bolt
1
A
x 4
2
A
x 4
7
A
C
C
AA
AA
A
B
AA
B
AA