VTech CS6324 User Manual page 34

My telephone Make sure the telephone
does not work base is installed properly,
at all. and battery is installed
and charged correctly.
For optimum daily
performance, return the
handset to the telephone
base after use.
The display Disconnect the telephone
shows No line. I line cord from your
cannot hear the telephone and connect it
dial tone. to another telephone. If
there is no dial tone on that
other telephone either,
then the telephone line
cord may be defective. Try
installing a new telephone
line cord.
If changing the telephone
line cord does not help,
the wall jack (or the wiring
to this wall jack) may
be defective. Contact
your telephone service
provider.
You may be using a new
cable or VoIP service, the
existing telephone jacks in
your home may no longer
work. Contact your service
provider for solutions.
I cannot dial out. Make sure there is a dial
tone before dialing. It
is normal if the handset
takes a second or two
to synchronize with the
telephone base before
producing a dial tone. Wait
an extra second before
dialing.
Eliminate any background
noise. Mute the handset
before dialing, or dial from
another room in your home
with less background
noise.
The display The handset is
shows To deregistered from the
register HS and
telephone base. Follow the
See manual steps in Register a handset
alternately. The to register the handset
handset does back to the telephone
not work at all. base.
The display
shows Low
battery.
The battery
does not charge
in the handset
or the handset
battery does not
accept charge.
The telephone
does not ring
when there is an
incoming call.
My handset
beeps and is
not performing
normally.
I hear noise on
the cordless
handset and
the keys do not
work.
I hear other calls
when using the
telephone.
27
Place the handset in the
telephone base or charger
for charging.
Make sure the handset is
placed in the telephone
base or charger correctly.
If the battery is completely
depleted, charge the
battery for at least
30 minutes before use.
You may need to purchase
a new battery.
Make sure the ringer
volume is not set to off.
The handset may be too
far from the telephone
base. Move it closer to the
telephone base.
Move the handset closer to
the telephone base. It may
be out of range.
Make sure the telephone
line cord is plugged in
securely.
Disconnect the telephone
base from the telephone
wall jack. Plug in a different
telephone. If you still hear
other calls, the problem is
probably in the wiring or
telephone service. Contact
your telephone service
provider.