Epson Stylus CX7300 Series Basic Operation Manual page 16

2. Press and release y Stop.
The ink cartridge holder moves to the
check position and the P On and B ink
lights flash. If one of the cartridges is
expended, the printer moves that
cartridge to the _ mark.
c Caution:
Be careful not to touch the white flat cable
inside the printer.
Note:
Do not hold down y Stop for more than three
seconds as this starts print head cleaning.
3. Press y Stop again.
■
If more than one cartridge is expended,
the next cartridge moves to the _ mark.
■
When all of the expended ink cartridges
have been identified, the print head
moves to the ink cartridge replacement
position.
16 Replacing Ink Cartridges
4. Open the cartridge cover.
c Caution:
Never attempt to open the cartridge cover
while the print head is moving. Wait until the
print head has stopped at the replacement
position.
5. Squeeze the tab, lift it straight up.
c Caution:
Do not refill the ink cartridge. Other products
not manufactured by Epson may cause
damage that is not covered by Epson's
warranties, and under certain
circumstances, may cause erratic printer
behavior.
Note:
If it is difficult to remove the cartridge, lift the
cartridge with more force until comes out.
6. Before you open the new ink cartridge
package, shake it four or five times. Then
remove it from the package.