Operation - RedMax HEZ2601S Owner's/Operator's Manual

OP1
OP2
OP3
OP4
(5)
(6)
(4)
OP5
26
(1)
(2)
(3)
(7)
English

8. Operation

The RedMax stick edgers are designed for edging lawn
in gardens, parks, roadsides and so on.
Before starting the engine, take the operating position
and adjust the handle position and the wheel height as
necessary.
■ ADJUSTING WHEEL HEIGHT
• Loosen the clamp lever and change the wheel height
to obtain desired cutting depth. (OP1)
(1) Deep cut
(2) Shallow cut
WARNING
• Never adjust wheel height with the engine
running.
■ STARTING ENGINE
WARNING
The cutting head will start rotating upon the engine
starts.
1. Rest the unit on a flat, firm place. Keep the cutting
head off the ground and clear of surrounding objects
as it will start rotating upon starting of the engine.
2. Push the primer pump several times until overflown
fuel flows out in the clear tube. (OP2)
3. Move the choke lever to the closed position. (OP3)
4. Set the ignition switch to the "Start" position. While
pulling the throttle lever, push the throttle set button,
and release the throttle, then the throttle lever is in to
the "Start position". (OP4)
5. While holding the unit firmly, pull out the starter rope
quickly until engine fires. (OP5)
(1) Choke lever (2) Close
(3) Open (4) Ignition switch
(5) Start (6) Stop
(7) Throttle set button
IMPORTANT
• Avoid pulling the rope to its end or returning it by
releasing the knob. Such actions can cause starter
failures.
6. Move the choke lever downward to open the choke.
And restart engine. (OP3)
7. Allow the engine to warm up for several minutes
before starting operation.