Any Problems - Epson Stylus CX5400 Start Here Manual

Adding the Stylus CX to Print Center
for Mac OS X
1
Open the OS X Applications folder,
then open the Utilities folder and
double-click Print Center.
If you see this screen, click Add.
2
If the Stylus CX5400 already appears in the printer list, click it,
then click Add.
If the Stylus CX5400 doesn't appear in the printer list, make sure it is
connected and turned on. Then click Add.
3
Select EPSON USB at the top of the next screen.
4
Click Stylus CX5400. The Page
Setup pull-down menu at the
bottom of the screen becomes
active.
5
Open the Page Setup pull-down
menu and select All.
6
Click the Add button. You see the
Printer List again with the Borderless
feature available.
7
Close Print Center. You're ready to copy,
scan, and print.
8
Now start up your Macintosh in OS 9.x. Follow the instructions in the
previous column to install the OS 9.x drivers and optional software for
Macintosh Classic programs.
Selecting the Stylus CX in the Chooser
for Mac OS 8.6 to 9.x
1
Open the Chooser from the Apple
menu. Select CX5400, then select
your USB port and turn on
background printing.
2
Close the Chooser. You're ready
to copy, scan, and print.

Any Problems?

If the red Error light is on, check the message on the Stylus CX. Try
turning the Stylus CX off and then back on to clear the error. If your problem
is listed here, try these suggestions. For more information, see your software
Help, Quick Reference Guide, or your on-screen EPSON Information Center.
The Found New Hardware
Wizard appears on
your screen.
You see an error message
when you try to print
or scan.
The Stylus CX
doesn't work.
Click Cancel and follow the steps in
section 7. Disconnect the Stylus CX
before installing the software.
Make sure your Stylus CX is connected to
your computer, plugged into a power
source, and turned on.
Make sure you removed the tape from the ink
cartridge holder, as described in section 1.
Turn the Stylus CX off and then on again.
Slide the transportation lock under the
lid to unlock the scanner. See section 2.
Make sure the ink cartridges are pushed
all the way down.
Make sure you're using the USB cable that
came with your Stylus CX. Try connecting
it to a different USB port on your computer.
Make sure your EPSON Stylus CX5400
software is installed correctly.