Table of Contents
Advertisement
16
CHAPTER 3
Installation
Power Requirements
Network Connection
Cables Required
Installation Guide: 601, 602, and 604 Routers
The OmniAccess 601, OmniAccess 602, and OmniAccess 604 router operates on 12 VDC power.
A 12 VDC power supply and an AC power cord are shipped with the router.
To successfully complete the installation, the router must be connected to a network. Before
you start the installation, make sure that a live network connection is available at the
installation site.
The OmniAccess 601, OmniAccess 602, and OmniAccess 604 router ships with a Console cable.
You will need to obtain additional cables for your specific application. The following additional
cables are required to install the OmniAccess 601, OmniAccess 602, and OmniAccess 604
router.
One or two RJ-45, male/male, category 5, 26 AWG (minimum), twisted-pair,
straight-through cable (Ethernet LAN connection)
See Table 25 on page 63 for cable pinout information.
Refer to Figure 8 on page 16 to identify this cable.
Figure 8 Ethernet Cable
One or two RJ-48C, male/male, category 5, 26 AWG (minimum), twisted-pair,
straight-through WAN cable
See Table 26 on page 63 for cable pinout information.
Refer to Figure 9 to identify this cable.
Site Preparation
Advertisement
Table of Contents
