Advertisement
TREE ASSEMBLY INSTRUCTIONS
Congratulations on purchasing your new tree from
Carefully follow the instructions below on how to quickly and easily set up your new tree.
Fig. A - Tree and Light Assembly
Quick Fold
Quick Fold
Quick Fold
Cinch
TM
Quick Fold
TM
Cinch
1
• Before you start to assemble your tree, choose an appropriate location near a wall outlet.
• Assemble the tree stand and place on a level surface. (See Fig. B)
Fig. B - Tree Stand Assembly
SET UP INSTRUCTIONS WITH QUICK FOLD
1
Section 2
Section 3
Section 1
Tree top
Tree stand
Each tree section is numbered
with a sticker. Please identify all
sections before assembling.
MODEL #: TG76P4861C00
Polygroup®!
Quick Set®
4
Connections
TM
Cinch
TM
Cinch
3
2
Click
2
Section 1
Tree stand
Insert Section 1 into the tree stand.
*Electrical Rating For The Tree
(For Indoor Use Only)
2.55A 120V 60Hz
Do Not Tamper
Internal Parts
Open the
protective
cover
Do Not Tamper
Internal Parts
Quick Set®
Connections
Open the
protective
cover
Quick Set®
Connections
Insert
Green Label
Foot Switch
Plug Into Wall
Outlet
Pull apart the legs of the stand so that they
are snapped into an x-shape, place the tree
stand on a level surface.
To close the stand, press the metal button
and fold the legs together.
TM
3
A
Cinch
Handle
B
Cinch Clip
C
A. Locate "Pull Here" tab and corresponding
Cinch Handle
B. Hold Cinch Clip firmly with one hand and
press down on clip
C. With Cinch Clip depressed, pull clip away from
tree until all branches are released.
1
Do Not Tamper
Internal Parts
Open the
protective
cover
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Polygroup TG76P4861C00
Summary of Contents for Polygroup TG76P4861C00
- Page 1 Each tree section is numbered press down on clip with a sticker. Please identify all C. With Cinch Clip depressed, pull clip away from sections before assembling. Insert Section 1 into the tree stand. tree until all branches are released. MODEL #: TG76P4861C00...
- Page 2 Tree top Section 3 Section 2 Section 2 Section 1 Section 1 Tree stand Tree stand Remove the protective cap of Section 1 Remove the protective cap of Section 2 and add Section 2. Release all branches and add Section 3. Release all branches Remove the protective cap of Section 3 using the same procedures described using the same procedures described...
- Page 3 TROUBLESHOOTING TIPS For Pre-lit Trees, If The Tree Does Not Illuminate 1. Please check to make sure that all plugs are properly connected and power cord is plugged into the wall outlet. (If the tree comes with a foot pedal, try stepping on the on/off button). 2.
Need help?
Do you have a question about the TG76P4861C00 and is the answer not in the manual?
Questions and answers