Unpacking And Removing Shipping Bolts - LG F2720SVTV Owner's Manual

Unpacking and Removing
Shipping Bolts
1
Lift the washing machine off the foam base.
• After removing the carton and shipping
material, lift the washing machine off the foam
base. Make sure the tub support comes off with
the base and is not stuck to the bottom of the
washing machine.
• If you must lay the washing machine down to
remove the carton base, always protect the
side of the washing machine and lay it carefully
on its side. DO NOT lay the washing machine
on its front or back.
Tub Support Carton base
(Optional)
2
Remove the bolt assemblies.
• Starting with the bottom two shipping
bolts, use the spanner (included) to fully
loosen all shipping bolts by turning them
counterclockwise. Remove the bolt assemblies
by wiggling them slightly while pulling them out.
Shipping
bolt
Retainer
3
Install the hole caps.
• Locate the hole caps included in the accessory
pack and install them in the shipping bolt holes.
Cap
NOTE
• Save the bolt assemblies for future use. To
prevent damage to internal components, DO NOT
transport the washing machine without reinstalling
the shipping bolts.
• Failure to remove shipping bolts and retainers
may cause severe vibration and noise, which
can lead to permanent damage to the washing
machine. The cord is secured to the back of the
washing machine with a shipping bolt to help
prevent operation with shipping bolts in place.
11