Upper Louver Removal; Lower Damper Assembly Removal - Haier AW07EH2VHA Service Manual

3. Take note of connection location and carefully remove
each connector.
4. Remove the 2 screws mounting the board in the box. They
in diagonal corners from each other.

Upper Louver Removal

1. Remove the filter cover and front cover.
2. Locate and remove the two screws mounting the upper
louver assembly to the case. They are on either end of the
assembly.

Lower Damper Assembly Removal

1. Remove the filter cover and front cover.
2. Disconnect the condensate drain.
3. Locate and remove the two screws mounting the damper
assembly to the case.
4. Pull on the right end of the assembly and rotate the
bottom of the assembly outward.
Note: When re-installing the damper assembly, first place the
front edge of the condensate drain pan into place then rotate
the bottom of the assembly into position.
Topic Title Testing
Replace Fan Motor
1. Remove filter cover, front panel, control box, upper louver
2. Remove the white plastic strap that hold the line set in
3. Locate the locking tabs on the left side of the evaporator
IMPORTANT: Great care should be taken to when performing
this step. Excessively moving the lineset that connects to the
flare can cause a refrigerant leak.
4. Slide the coil to the right to. The coil can now be gently
CONSOLE TECHNICAL OVERVIEW
and bottom damper.
place on the right side of the unit.
and press them inward and pull the coil forward to remove.
pulled away from the case. Only move the coil far enough
to access the four screws holding on the fan inlet faring.
I-5