Turn On; To Choose A Boost Mode Session; To Choose A Standard Mode Session; Standard Mode - BAT glo HYPER+ User Instructions

47
03

Turn on

This glo™ tobacco heater
has two heating modes:
'STANDARD' and 'BOOST'.
You can choose either a
EN
STANDARD or BOOST mode
when you start a session.

To choose a STANDARD mode session:

Hold down the control button on the glo™ tobacco heater
for 3 seconds to start the heating process. The glo™ tobacco
heater will vibrate gently after these 3 seconds to indicate
that the session has been started and the control button
should be released. The first light on the control button will
begin to flash indicating BASE mode has been selected.
The lights will become solidly illuminated as the device
heats up.
After 20 seconds, all four lights on the glo™ tobacco heater
will be solidly illuminated and the glo™ tobacco heater will
vibrate gently to indicate that it is ready to use.
STANDARD Mode: Time until use
20 seconds
15 seconds
10 seconds
5 seconds
Ready to use
X1

To choose a BOOST Mode session:

Hold down the control button on the glo™ tobacco heater for
5 seconds to start the heating process. The glo™ tobacco heater
will vibrate gently after 3 seconds, and then again at 5 seconds to
indicate a session has started. Release the control button after the
second vibration.
The lights on the control button will begin to rotate to indicate that
BOOST mode has been selected. After 15 seconds, all four lights
on the glo™ tobacco heater will be solidly illuminated and the glo™
tobacco heater will vibrate gently to indicate that it's ready to use.
BOOST Mode: Time until use
5sec
Ready to use
48
X2
EN