Cleaning The Water Intake Filters; Draining Remaining Water And Cleaning The Pump Filter - Beko WTG620M1W User Manual

4.7.4 Cleaning the water intake filters

There is a filter at the end of each water intake valve at the rear of the product and also
at the end of each water intake hose where they are connected to the tap. These filters
prevent foreign substances and dirt in the water to enter the product. Filters should be
cleaned as they do get dirty.
1. Close the taps.
2. Remove the nuts of the water intake hoses to access the filters on the water intake
valves. Clean them with an appropriate brush. If the filters are too dirty, remove them
from their places with a pliers and clean in this way.
3. Take out the filters on the flat ends of the water intake hoses together with the
gaskets and clean thoroughly under running water.
4. Replace the seals and filters carefully and tighten their nuts by hand.

4.7.5 Draining remaining water and cleaning the pump filter

The filter system in your product prevents solid items such as buttons, coins and fabric
fibres clogging the pump impeller during discharge of washing water. Thus, the water will
be discharged without any problem and the service life of the pump will extend.
If the product fails to drain water inside it, the pump filter is clogged. Filter must be
cleaned whenever it is clogged or every 3 months. Water must be drained off first to clean
the pump filter.
In addition, prior to transporting the product (e.g., when moving to another house) water
should be drained completely.
A
CAUTION:
cause noise problem.
CAUTION:
hose must be removed and the water inside the product must be drained when the product
is not in use.
CAUTION:
Washing Machine / User's Manual
Foreign substances left in the pump filter may damage your product or may
In regions where freezing is possible, the supply tap must be closed, system
After each use, turn off the water tap to which the mains hose is connected.
33 / EN