Removing The Transportation Locks; Connecting The Water Supply - Beko WTG620M1W User Manual

4.4.3 Removing the transportation locks

1 Loose all bolts with an appropriate wrench until they turn freely.
2 Remove the transport safety bolts by rocking them slightly.
3 Insert the plastic covers from the bag containing the user manual into the openings on
the rear panel.
A
CAUTION:
machine! Otherwise, the product will be damaged.
C
Keep the transportation safety bolts in a safe place to reuse when the washing machine
needs to be moved again in the future.
Install the transport safety bolts in the reverse order of the disassembly procedure.
Never move the product without the transportation safety bolts properly fixed in place!

4.4.4 Connecting the water supply

C
The water supply pressure required to run the product is between 1 to 10 bars (0.1 – 1 MPa).
It is necessary to have 10 – 80 litres of water flowing from the fully open tap in one minute
to have your machine run smoothly. Attach a pressure reducing valve if the water pressure is
higher.
A
CAUTION:
In such a case the laundry will get damaged or the product will switch to protection mode and
will not operate.
CAUTION:
stains on your laundry.
1 Tighten the nuts of the hose by hand. Never use a tool when tightening the nuts.
2 When hose connection is completed, check whether there are no leak problems at the
connection points by opening the taps fully. If any leaks occur, turn off the tap and
remove the nut. Retighten the nut carefully after checking the seal. In order to prevent
the water leaks and resultant damages, keep the taps closed when you do not use the
product.
Washing Machine / User's Manual
Remove the transportation safety bolts before operating the washing
Models with a single water inlet should not be connected to the hot water tap.
Do not use old or used water inlet hoses on the new product. It may cause
13 / EN