Hyundai HYCH15100TE Instruction Manual page 27

AFTER ANY BLADE OR WEAR PLATE MAINTENANCE OR ADJUSTMENT, ROTATE THE
CHIPPER DISK BY HAND. WATCH AND LISTEN CAREFULLY FOR ANY UNUSUAL
NOISES, CLICKING OR VIBRATION. IF ANY OF THESE ARE DETECTED, INSPECT THE
MACHINE FOR DAMAGE, REPAIR OR REPLACE ANY DAMAGED PARTS AND CHECK
FOR ANY LOOSE PARTS AND RETIGHTEN.
KNIVES MUST BE CHECKED AND MAINTAINED!
BE SURE TO REINSTALL THE KNIFE CORRECTLY AND DOUBLE
CHECK FOR TIGHTNESS!
CHANGING OIL
•
Your chipper is equipped with an oil drain valve to make changing the oil easy.
•
The valve is located on the engine, on the towing side of the machine.
•
Place engine level.
•
Disconnect spark plug wires and keep it away from spark plugs. Disconnect
battery (if equipped with electric starter) at negative terminal.
•
With engine OFF but still
receptacle.
Note: To open valve, push in and turn counterclockwise.
•
Close oil drain valve.
•
Remove oil fill
•
Fill to FULL mark on dipstick with new oil. Do not overfill.
Note: Engine holds approximately
changing oil and filter.
• Replace oil filler
KNIVES MUST BE SHARP!
warm, open oil drain valve and drain oil into appropriate
(if equipped).
cap
1200ml of SAE30 or 15w40 engine oil
cap and dipstick
ALWAYS USE GLOVES.
25
when