Download Print this page

Dakota Digital Odyssey CLK-57C Quick Start Manual page 2

Advertisement

Wiring:
BLACK -
connect to a good ground point in the vehicle.
RED
-
ORANGE
-
BLUE
-
Mounting:
The CLK-57C clock is designed to fit into the stock clock location. It should be inserted into the opening
from the front and the U-clamp will be installed from the back. Tighten the two nuts on the U-clamp so that the
gauge is secure.
Problem
Clock will not light up
Clock will not turn off when
the key is off.
Clock lights up, but does
not read correctly.
Clock will not keep time.
Clock will not dim.
Clock remains dim at all
times.
Technical specifications
Minimum operating voltage
Maximum operating voltage
(operating at or near maximum rating for an extended time can damage unit)
Clock accuracy
Typical current draw (@ 13.8V) -
Standby current draw (key off)
connect to switched 12 volt power point.
(An accessory terminal will work for this.)
connect to a constant 12 volt power point.
(This will keep the correct time.)
connect to the tail light circuit.
Troubleshooting guide.
Possible cause
Red wire does not have
power.
Orange wire does not have
power.
Black wire is not getting
a good ground.
Power is reversed.
Clock is damaged.
The red and orange wires
are reversed.
Loose connection on orange
power wire.
Poor ground connection.
Time is not set.
Clock is damaged.
Orange wire does not have
constant power.
Loose connection on orange
power wire.
Poor ground connection.
Blue wire is not connected
correctly.
Blue wire is getting power
all of the time.
Battery is very low.
Clock is damaged.
-
7 volts
-
18 volts
2 minute per month
-
0.13 A
-
0.002 A
Solution
Connect to a location that has power
when the key is on.
Connect to a location that has power
all of the time.
Connect ground to a different location.
Connect black to negative ground, red and
orange to +12V power.
Return clock for repair. (see instructions)
Connect the red to switched power, the
orange to constant power.
Reconnect orange wire.
Move ground to different location
Set time. (see instructions)
Return clock for repair. (see instructions)
Connect to a location that has power when
the key is on or off.
Reconnect orange wire.
Move ground to different location
Check wiring connections.
Connect blue wire to location that only
has power when the headlights are on.
Recharge or replace vehicle battery.
Return clock for repair. (contact factory)
MAN# 650013;B

Advertisement

loading