Table of Contents
Advertisement
INSTALLING THE ADAPTERS
• Remove the protective backplate (1) from the selected slot, as
shown in Figure 2-2. Loosen the thumbscrew (2) holding the
backplate (1) in place over the selected slot, and slide the
backplate out of the slot.
1
2
3
Figure 2-3. Installing the F3069 Adapter
• Orient the adapter (2, Figure 2-3) so the computer bus edge
connector (3) is pointed down, and the FDDI port faces out the
back of the computer as shown.
• Align the adapter so the computer bus edge connector is lined
up with the expansion slot (4, Figure 2-3).
• Slide the adapter into the guide slots and firmly press, but do
not force, the adapter into the expansion slot. In most Micro
Channel machines, the plastic clips on the F30XX Micro
Channel adapter (1, 5, Figure 2-3) will snap into place as the
adapter is inserted into the expansion slot.
• Tighten the thumbscrew on the rear panel bracket of the
computer. Replace the computer cover, reconnect all cables,
and power up the computer.
Page 2 - 4
4
5
Advertisement
Table of Contents
