Shift Mode; Volume; Swing; Tempo - Traktor MK3 EXTENDED User Manual

2.2.4. Push up or pull down to select your selected* Remix Deck "Sample Pages"
NOTE: this only applies to Decks C and D when they are REMIX Decks
2.3. "Shift" mode (press and hold the new "Shift" button)
2.3.1. Press and hold Shift + Turn to select Decks A, B, C, or D
D is selected because the green light is at the bottom ( to the left is A, top is B, right
is C and the bottom one is D)
2.3.2. Press and hold Shift + push left to select* Remix Deck C
2.3.3. Press and hold Shift + push to the right to select* Remix Deck D
NOTE: Remix Decks C and D share some knobs and buttons so you must select
which one you are controlling by using the procedure mentioned above
2.4. "VOLUME"- Press and hold while turning the 4-Way encoder to adjust the Master
Volume Level
2.5. "SWING"- Press and hold while turning the 4-Way encoder to adjust the Swing (Shuffle)
level of your Step Sequencer
2.6. "TEMPO"- when used together with the encoder, adjust the Master tempo
2.7. "LOCK" - same as above but in smaller increments for accuracy
2.8. "PERFORM FX Select" - same as above but this time it selects one of the "Mixer Effect"
(Filter, Reverb, etc.) assigned to the Deck Selected.

3. TOUCHSTRIP

NOTE: the Touchstrip functions (Pitch, MOD, Perform FX, and NOTES) are toggle
buttons and only affect the selected deck. They can only be used one at a time; if you
press more than one, only the last button to be pressed will be on.
3.1. It performs several functions depending on the mode you've selected with the buttons
right above it.
3.2. Press "PITCH" and the Touchstrip will turn into a Pitch fader. Slide your finger right to
increase the Tempo, and to the left do decrease (does not work if "SYNC" is active)
3.3. Press "MOD" to turn the Touchstrip into a Jogwheel-turn, to nudge an out of phase track
(this only works when a track is playing and when SYNC is off)
3.4. Press "PERFORM FX Select" to adjust "Mixer Effects" for the selected deck.
the light bar on the touchstrip matches the position of the Mixer FX knob and will reset
back to the center position when you let go off. To prevent the FX from resetting, press
the MOD button before letting go off of it).
3.5. The NOTES button turns the touchstrip into the Key knob. It also resets when you lift
your finger off the touchstrip and can be locked into place by pressing MOD before
breaking contact with the touchstrip.
. On this example Deck
(v1.4 update: