First Things First; The 4-Way Encoder; Normal Mode - Traktor MK3 EXTENDED User Manual

1.

First things first...

1.1. The "SHIFT" button on your MK3 is not used on this mapping. From this point on, we
will refer to the "FOLLOW/Grid" button (above "SHIFT" and below "H") as "Shift"
1.2. Whenever you see two functions separated by a "/" that means that you need to press and
hold "Shift" to activate the one to the right of the "/"
1.3. Keep in mind that most Knobs are set to "soft take-over" so before you begin make sure
you fully turn them into both directions to update, otherwise, they may seem
unresponsive at first. This was done for two reasons: to have the nice display bars instead
of numbers (CC values) on the screens and to prevent a slider or controller to jump all
the way up or down, causing an undesired effect.
NOTE: Always press and hold "Shift" first, then the other button/knob

2. The 4-Way Encoder

depending on its mode
2.1. "BROWSER" Mode
2.1.1. Press browser to search for files
2.1.2. Push the encoder to the left or to the right and then scroll by turning the encoder.
NOTE: by default, the encoder will scroll through tracks and remix sets. You must
click to the left to navigate file folders
2.1.3. If you went to the left (to the folders) you can scroll up and down your folders.
2.1.4. Open or close a folder by pushing up or down on the encoder
2.1.5. Once you selected your folder, go to the Right, scroll for the Track, Remix Set, or
Sample that you want to load, and push the center of the encoder to "LOAD" it to the
Selected Deck
automatically)

2.2. Normal Mode

2.2.1. when pushed, it will activate "LOOP" on the Deck selected; push again to turn off
"LOOP"
2.2.2. Turn to change "LOOP SIZE"
2.2.3. Push left or right and it will move the loop on either direction
USER GUIDE
is key to navigate your controller. It performs multiple functions,
(version 1.3 update: it no longer syncs the newly loaded track
(this is an update on version v1.3)
(v 1.3 update)