LG I24TTP Owner's Manual page 37

Symptoms
Air is not circulating properly.
• Make sure that there are no curtains, blinds, or pieces of furniture
The micro dust filter is dirty.
• Clean the micro dust filter once a month.
• See "Replace and Clean the Micro Dust Filter" for more information.
The room temperature is too high.
• In summer, cooling the indoor air fully may take some time. In this case,
Cold air is escaping from the room.
• Make sure that no cold air is escaping through the ventilation points in
The air conditioner
does not emit cool
The desired temperature is higher than the current temperature.
air.
• Set the desired temperature to a level lower than the current
There is a heating source nearby.
• Avoid using heat generators like electric ovens or gas burners while the
Fan Mode is selected.
• During Fan Mode, air blows from the air conditioner without cooling or
• Switch the operation mode to cooling operation.
Outside temperature is too high.
• The cooling effect may not be sufficient.
The Jet Mode, or Auto Operation Mode is selected.
The fan speed
• In some operation modes, you cannot adjust the fan speed. Select an
cannot be adjusted.
The Fan Mode or Jet Mode is selected.
The temperature
• In some operation modes, you cannot adjust the temperature. Select an
cannot be adjusted.
The air conditioner is suddenly turned off.
• The Timer Function may have timed out, which turns the unit off. Check
The air conditioner
stops during
A power failure has occurred during operation.
operation.
• Wait for the power to come back. If you have the Auto Restart function
Possible Causes & Solution
blocking the front of the air conditioner.
select the Jet Mode to cool the indoor air quickly.
the room.
temperature.
air conditioner is in operation.
heating the indoor air.
operation mode in which you can adjust the fan speed.
operation mode in which you can adjust the temperature.
the timer settings.
enabled, your unit will resume its last operation several minutes after
power is restored.
EN
37