Installation - Electrolux BGB101011M User Manual

18 www.aeg.com

12. INSTALLATION

WARNING!
Refer to Safety chapters.
12.1 Gas connection
WARNING!
Before the gas connection,
disconnect the mains plug
from the mains socket or
deactivate the fuse in the
fuse box. Close the primary
valve of the gas supply.
The gas supply ramp is on the rear side
of the appliance.
WARNING!
Do not use rubber flexible
pipes!
Do not fully put the oven into the built-in
cabinet (approximately 30 cm).
Connection with a flexible metallic
pipe or a rigid metallic pipe:
A. Gas supply ramp, end of shaft with
ramp
B. Washer
C. Elbow
Put the supplied gasket between the
pipe and the gas supply ramp. Turn the
pipe to the 1/2" gas supply ramp.
1. Use a 22 mm spanner to tighten the
nuts. Keep the gas supply ramp in
the correct position. Do not apply
force to the gas supply circuit.
WARNING!
Do not use a flame to
check for leaks!
2. Fully move the oven into the built-in
cabinet.
A B C
WARNING!
Do not squeeze the gas
supply ramp and the
pipe when you move the
oven into the built-in
cabinet.
3. Seal the connection correctly. Use a
leak detection to control it.
12.2 Adjustment to different
types of gas
Only a qualified technician is
authorized to handle
adjustment of different types
of gas.
The oven is set for natural
gas, you can change it to
liquid gas, with the correct
injectors.
If the oven is set for liquid
gas, you can change it to
natural gas, with the correct
injectors.
The gas rate is adjusted to
suit.
WARNING!
Before you replace the
injectors, make sure that the
gas knobs are in the Off
position. Let the oven cool
down. There is a risk of
injury.
12.3 Gas grill injector
replacement
1. Release the screws which keep the
grill burner in position (A).
2. Carefully move forward the burner off
the injector support. Slowly move it
A