SolidRun HummingBoard Series Quick Start Manual page 4

Id Interface
1 Micro USB
2 HDMI
3 Dual Internal
USB
note
:
4 Ethernet
5 CSI Module
6 Dual USB
7 RTC Backup
battery
connector
8 Infra RED Rx
9 Reset Button
10 Analog Audio
11 SPDIF Output
12 Mini PCIe
13 GPIO Header
14 LVDS
Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from
Figure 3 RTC Generation Circuit using NXP's PCF8523
Description
MicroUSB type connector for powering the
HummingBoard and its accessories. User
must connect a 5V limited power supply.
See below safety notices for further safety
instructions.
Full HD HDMI output. Connect to your TV
set.
Two powered internal USB ports. Do not
overload with more than 0.25A current
consumption.
The indicator LED shares the IR receiver window .
Connect to your Ethernet switch or router
for local wired networking (LAN).
CSI connector for camera modules
Two powered USB port. Connect your USB
device such as Keyboard, Mouse, HD, etc...
Do not overload with more than 0.5A
current consumption.
Infra Red receiver for remote control
support. Running application must support
this functionality.
This is a hardware reset button.
SPDIF Coaxial Output.
Half length (short) mini PCIe module
connector for expansion.
26 pin GPIO Header for input and output of
digital signals from expansion boards and
wire-ups.
LVDS connector with support of flat LCD
I1-310-D, I2eX-310-D,
I2-310-D I4-310-D
Use 5V/2A Use 5V/2A
(See safety (See safety
section section
below) below)
Supported Supported
Not Supported
supported
Fast Gigabit
Ethernet Ethernet
Supported Supported
Supported Supported
Not Supported
supported
(See safety
section
below)
Not Supported
supported
Supported Supported
Mono Stereo
output output and
PWM tune MIC input
generator
Supported Supported
Not Supported
supported
Supported Supported
Not
Supported
| P a g e
4