Advertisement
AR-FN3
8. Elevator wires, top and bottom
3)
1)
2)
1)
2)
(A)
[Note] If the tray 3 is not at the upper limit position, turn the knurled
part on the shaft (A) in the sketch and move tray 3 to the
upper limit position.
8)
8)
8)
8)
8/19/1999
6)
4)
5)
5)
4)
5)
5)
8)
7)
7)
8)
9)
11)
10)
10)
12)
13)
[Note] Remove the two screws 13) and:
1) Move the off-set tray to the lower limit position.
2) Turn the knurled part on the elevator worm gear shaft under the
elevator drive box so that the D-cut surface on the winding pulley
points upward.
[Note] Remove the elevator wires (top, bottom) at the rear frame
side in the same manner.
5 – 5
10)
13)
C
14)
15)
17)
A
18)
16)
B
12)
Advertisement
