Advertisement
[6] ADJUSTMENTS
The following table shows the main parts requiring adjustment at the
time of replacement
Item
1
Jogger F/R
2
Paper discharge gate solenoid 1
3
Paper discharge gate solenoid 2
4
Paper discharge gate solenoid 3
5
Paper holding solenoid
6
Paddler clutch
7
Vertical transport de-curler
Note: Remove or install parts in numerical order shown in the follow-
ing figures.
1. Jogger F/R
A. Let the unit staple 5 sheets of A4 or letter paper and check the
bundle of the sheets for deviation in directions A).
Pin
B. If the deviation in directions A) are within 1 mm, there is no need
to adjust the jogger F/R.
C. When the deviation exceeds 1 mm, adjust the jogger F/R accord-
ing to the simulation 3-6: Adjusting Finisher Jogger Position.
Sim. 3-6: Adjusting Finisher Jogger Position
The screen above is displayed after the sub number of the simulation
is entered.
1) Adjust the value with the numeric keypad.
2) The joggers in the finisher are operated by pressing the [EX-
ECUTE] key. The [EXECUTE] key is displayed in reverse video
during loading operation. When the [EXECUTE] key in this state
is pressed, loading operation can be canceled.
Condition
1
When the
Decrease the simulation value.
deviation in the
(Decreasing the simulation by 1 narrows
direction A)
the width between the joggers by 0.63
exceeds 1 mm.
mm.)
Increase the simulation value. (Increasing
the simulation value by 1 widens the width
between the joggers by 0.63 mm)
Note: The width between joggers can be visually checked by observ-
ing the label inside the staple tray.
Part name
A)
Adjusting procedure
Letter position
2. Paper discharge gate solenoid 1
6 – 1
AR-FN3
Jogger
Label
A
Jogger
A4 position
The spacing between
labels is 0.5 mm.
3)
2)
2)
8/19/1999
1)
2)
1)
2)
Advertisement
