Bio Bronpi ELSA Y PAULA Installation, Operating And Servicing Instructions page 52

10.4.7.4. SUBMENU TEST RADIO
This menu allows to verify the connection between the remote control and the electronic card. This test allows to verify the level of pollution
of the electromagnetic waves. The remote control is continuosly sending and receiving data from the card, checking right and wrong
transmissions. The quality of the signal depends on the number of wrong transmissions. In order to interrupt the test, press ESC.
10.4.7.5. SUBMENU CHANGE CODE
The change of the code allows to link the remote control with a particular electronic card. In this way, the remote control is only linked with one
stove. This allows the existence of different stoves in a particular area. In order to change the code, it is necessary to follow the next steps:
- Choose the code from the list that appears in the remote control, for example, 998. But do not press SET. This will be done later (see
drawing D90).
- Enter into the "Learning menu" in the receiver of the stove. In order to do this, press simultaneously during 3 seconds keys P3 and P4.
Later, press key P2 until the display D1 shows the word "LEAr". Then, press the submenu with key P3. Press again key P3 so that the
display D1 shows "----" flashing (see drawing D91).
- After this, press key SET of the remote control so that the synchronisation is made with the code chosen. If the synchronisation is
correct, the display will show the text "Learning successful". On the contrary, it will show the text "Transferring failed" and you should
repeat the previous steps (see drawing D92).
- - - -
ESC
D90
10.4.7.6. SUBMENU SET CONTRAST
This menu allows to modify the contrast of the screen of the remote control. Select with the keys
10.4.7.7. SUBMENU MUTE CLAVES
This menu allows to activate or deactive the sound when you press a key of the remote control. By default,
this option is activated and if you want, it is possible to deactivate it by pressing the keys
D93).
10.4.7.8. SUBMENU LANGUAGE
It allows to select the language of the remote control. You can access this menu by pressing the key SET and
choose the language desired among those available: Spanish, Portuguese, French, German, English
and Italia and confirm with the key SET.
10.4.8. SYSTEM MENU
This menu allows to access the technical menu. It is protected with a password and it can only be accessed
by the Technical Assistance Service. If someone not authorised by Bronpi Calefacción access this menu, this
means the loss of the warranty.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
GS W
Change Code
998
999
1000
1001
1002
D91
(see drawing
51
Learning
successful
D92
Key tone
.
Enabled
Disabled
ELSA AND PAULA
D93