Bio Bronpi ELSA Y PAULA Installation, Operating And Servicing Instructions page 47

Mon 13:22
Modulation
18º
22º
º
D69
burner each time set by Bronpi.
This cleaning lasts a few seconds seconds and consists in cleaning the rests of pellet placed in the burner
in order to make easier the operation of the stove. When this happens, the display will show the following
messages (see drawing D70):
Mon 13:22
Extinguish
18º
22º
º
D71
10.3.8. REIGNITION OF THE STOVE
Once the stove is turned off, it is not possible to reignite again until a safety
time has elapsed and the stove is cold enough. If you try to ignite the stove,
the display will show the messages on drawings D72 and D73.
Mon 13:22
OFF
18º
º
º
D74
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
10.3.4. POWER SET-UP
This option is only available inside the user menu. See section 10.4.1.1.
10.3.5. THE ROOM TEMPERATURE REACHES THE TEMPERATURE FIXED BY THE USER
When the room temperature reaches the value fixed by the user or the smoke temperature reaches a value
too high, automatically, the stove starts working at a lower power. The stove modulates. See drawing D69.
If after this time, the room temperature continues increasing, the stove turns off and it will turn on again when
the room temperature is below the temperature set point.
10.3.6. BURNER CLEANING
During the normal operation of the stove, there are automatic cleanins of the
10.3.7. SWITCHING OFF THE STOVE
In order to turn off the stove, simply press the key
Once the stove is turned off, it starts the final cleaning phase in which the
pellet feeder stops and the smoke extractor and the tangential fan start
working at maximum speed. This cleaning phase will not stop until the stove
reaches the appropriate cooling temperature (see drawing D71).
10.3.9. STOVE SWITCHED OFF
Drawing D74 shows the information of the display when the stove is turned off.
during a few seconds.
Ignition in
Progress
Please wait
D72
46
Mon 13:22
Cleaning on
18º
22º
º
D70
Ignition
Failed
D73
ELSA AND PAULA