Bio Bronpi ELSA Y PAULA Installation, Operating And Servicing Instructions page 43

- Step 2
0 0 : 0 0
ESC
   
D45
1 3 : 0 0
ESC
GS
9.4.1. IGNITION OF THE STOVE
In order to ignite the stove, simply press the key P1 during a few seconds. Firstly, the stove carries out an initial check-up and continues the
ignition process. After this, the display shows different steps of the ignition process (2, 3 and 5) (see drawings D48, D49,D50 and D51).
The maximum duration of the ignition phase is 20 minutes. If after this time there is not flame, the stove will automatically activate the alarm
state and the display will show the alarm message "Er12".
ESC
GS W
9.4.2. STOVE IN OPERATION
Once certain smoke temperature has been reached, the hot air fan starts working.
Once the ignition phase has been finished properly, the stove enters into "Work"
mode which represents the normal operating mode (see drawing D52).
The display shows the time, the working power and the room temperature.
1 3 : 0 0
ESC
 
GS
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
GS W
9.4.
The normal operation of the display/receiver is described below.
Before switching on the display, the stove state is showed in drawing D47. It only
3
shows the room temperature and the current time.
W
D47
ESC
GS
D48
9.4.3.
Press key P2 or P4 and the display D4 will start flashing. By pressing keys P2 or
P4, it is possible to select the temperature desired for the room (see drawing D53).
After 5 seconds, the new value will be saved and the display will return to the
W
normal state.
D53
0 7 : 5 9
ESC
   U
D46
USER MODE
ESC
W GS
D49
ESC
ADJUSTMENT OF THE ROOM TEMPERATURE
42
GS W
ESC
W GS
D50
1 3 : 0 0
3 0
GS W
W
D51
D52
ELSA AND PAULA