Advertisement
Quick Links
INSTALLATION AND OPERATION MANUAL
TRANSMISSION JACKS
MODELS:
RTJ-1
RTJ-660
RTJ-1100
RTJ-3000
SHIPPING DAMAGE CLAIMS
When this equipment is shipped, title passes
to the purchaser upon receipt from the carrier.
Consequently, claims for the material damaged in
shipment must be made by the purchaser against the
transportation company at the time shipment is received.
PLEASE READ THE ENTIRE CONTENTS OF THIS MANUAL PRIOR TO
INSTALLATION AND OPERATION. BY PROCEEDING YOU AGREE THAT
YOU FULLY UNDERSTAND AND COMPREHEND THE FULL CONTENTS OF
THIS MANUAL. FORWARD THIS MANUAL TO ALL OPERATORS. FAILURE TO
OPERATE THIS EQUIPMENT AS DIRECTED MAY CAUSE INJURY OR DEATH.
RTJ-1 Shown
Keep this operation manual near the
machine at all times. Make sure that
ALL USERS read this manual.
BE SAFE
Ranger™ Transmission Jacks are designed and
built with safety in mind. However, proper training
and thoughtful operation on the part of the operator
can increase your overall safety. DO NOT operate
or repair this equipment without reading this manual
and the important safety instructions shown inside.
REV A 09-05-08
1645 Lemonwood Dr.
Santa Paula, CA. 93060, USA
Tel: 1-805-933-9970
Toll Free: 1-800-253-2363
Fax: 1-805-933-9160
www.rangerproducts.com
Advertisement
Related Manuals for Ranger Products RTJ-1
Summary of Contents for Ranger Products RTJ-1
- Page 1 MODELS: RTJ-1 RTJ-660 RTJ-1100 RTJ-3000 Keep this operation manual near the RTJ-1 Shown machine at all times. Make sure that ALL USERS read this manual. BE SAFE SHIPPING DAMAGE CLAIMS Ranger™ Transmission Jacks are designed and When this equipment is shipped, title passes to the purchaser upon receipt from the carrier.
-
Page 2: Warranty Policy
Defective parts replaced at no charge must be returned Keeps chains secured until ready to remove to your dealer or Ranger Products™ within 60 days of the transmission form jack. DO NOT tow loaded jack date that the replacement parts are shipped; otherwise, by hydraulic pump handle. - Page 3 Locate the four Casters and attach them to the bottom of the ends of the four Legs. Use the four nuts and bolts with the washers for each leg, ensure they are RTJ-1 well tightened. Locate the two, “leg assemblies”, and attach each...
- Page 4 RTJ-1100 RTJ-3000 Attach the two, Leg Assemblies to the block on Locate the two, Leg Assemblies, and attach each Hydraulic Cylinder Assembly, using the hex head bolts assembly to the bottom of the Hydraulic Cylinder using and washers. the three bolts and washers. Locate the four Casters and attach them to under Attach the Casters to the ends of each leg, one carriage through the holes provided.
- Page 5 For additional copies or further information, contact: With the vehicle elevated on lift, position jack beneath transmission, as nearly as possible to the BendPak, Inc. / Ranger Products transmission’s center of weight or balance point. 1645 Lemonwood Dr., Santa Paula, CA. 93060...
- Page 10 For Parts Or Service Contact: BendPak Inc. / Ranger Products 1645 Lemonwood Dr. Santa Paula, CA. 93060 Tel: 1-805-933-9970 Toll Free: 1-800-253-2363 Fax: 1-805-933-9160 www.bendpak.com www.rangerproducts.com...
Need help?
Do you have a question about the RTJ-1 and is the answer not in the manual?
Questions and answers