Table of Contents
Advertisement
Quick Links
INSTALLATION AND OPERATION MANUAL
Low Profile
Long Frame Floor Jack
Model: RFJ-3000LPF
REV B
SHIPPING DAMAGE CLAIMS
When this equipment is shipped, title passes
to the purchaser upon receipt from the carrier.
Consequently, claims for the material damaged in
shipment must be made by the purchaser against the
transportation company at the time shipment is received.
PLEASE READ THE ENTIRE CONTENTS OF THIS MANUAL PRIOR TO
INSTALLATION AND OPERATION. BY PROCEEDING YOU AGREE THAT
YOU FULLY UNDERSTAND AND COMPREHEND THE FULL CONTENTS OF
THIS MANUAL. FORWARD THIS MANUAL TO ALL OPERATORS. FAILURE TO
OPERATE THIS EQUIPMENT AS DIRECTED MAY CAUSE INJURY OR DEATH.
BE SAFE
Ranger™ Floor Jacks are designed and built
with safety in mind. However, proper training and
thoughtful operation on the part of the operator can
increase your overall safety. DO NOT operate or
repair this equipment without reading this manual
and the important safety instructions shown inside.
REV B 02-05-15
1645 Lemonwood Dr.
Santa Paula, CA. 93060, USA
Tel: 1-805-933-9970
Toll Free: 1-800-253-2363
Fax: 1-805-933-9160
www.rangerproducts.com
Advertisement
Table of Contents
Related Manuals for Ranger Products RFJ-3000LPF
Summary of Contents for Ranger Products RFJ-3000LPF
- Page 1 OPERATE THIS EQUIPMENT AS DIRECTED MAY CAUSE INJURY OR DEATH. REV B 02-05-15 INSTALLATION AND OPERATION MANUAL Low Profile Long Frame Floor Jack Model: RFJ-3000LPF REV B BE SAFE SHIPPING DAMAGE CLAIMS Ranger™ Floor Jacks are designed and built When this equipment is shipped, title passes with safety in mind.
-
Page 2: Warranty Policy
For Parts Or Service Contact: Defective parts replaced at no charge must be returned to your dealer or Ranger Products™ within 60 days of the BendPak Inc. / Ranger Products date that the replacement parts are shipped; otherwise, you must pay for the replacement parts at the current 1645 Lemonwood Dr. -
Page 3: Owner/Operator Responsibility
THIS OPERATING MANUAL CONTAINS ALTERATIONS IMPORTANT DETAILS CONCERNING THE Because of potential hazards associated with this type of SAFE OPERATION OF THIS TOOL. THE equipment, no alterations shall be made to the product. USER MUST READ AND UNDERSTAND THESE DETAILS BEFORE ANY USE OF THE FOR YOUR SAFETY AND TO PREVENT INJURY: TOOL. -
Page 4: Operation
ASSEMBLY INSTRUCTIONS Lower the load to rest on the jack stands. Then, make sure that the release valve on the jack is closed tightly (twist the Handle clockwise). 1. Assemble Upper and Lower Handle, insert into Handle Socket and tighten Bolt. 2. -
Page 5: Troubleshooting
TROUBLESHOOTING PROBLEM ACTION 1. Unit will not lift load Purge air from hydraulic system by following procedure un- der OPERATING INSTRUCTIONS. 2. Unit will not sustain load or feels “spongy” under load. Purge air from hydraulic system as above. 3. Unit will not lift to full height. Purge air from hydraulic system as above. -
Page 6: Parts Breakdown
PARTS BREAKDOWN... - Page 7 PARTS BREAKDOWN...