Installation Notes - Pioneer AVIC-Z630BT Instruction Manual

• DAB aerial and its lead (AVIC-Z930DAB/
AVIC-Z830DAB/AVIC-Z730DAB/AVIC-
Z7330DAB)
• GPS aerial and its lead
In addition, you should lay or route each
aerial lead as far as possible from other
aerial leads. Do not bind, lay or route them
together, or cross them. Electromagnetic
noise will increase the potential for errors
in the vehicle's location display.
Before installing
• Consult with your nearest dealer if
installation requires drilling holes or
other modifications of the vehicle.
• Before making a final installation of this
product, temporarily connect the wiring
to confirm that the connections are
correct and the system works properly.
For AVIC-Z930DAB and AVIC-
Z830DAB users
Do not install this product in a position
where the opening of the LCD panel is
obstructed by any obstacles, such as the
gearstick. Before installing this product, be
sure to leave sufficient space so that the
LCD panel does not obstruct the gearstick
when it is fully opened. This may cause
interference with the gearstick, or a
malfunction of the mechanism of this
product.

Installation notes

• Do not install this product in places
subject to high temperatures or
humidity, such as:
– Places close to a heater, vent or air
conditioner.
– Places exposed to direct sunlight, such
as on top of the dashboard.
– Places that may be exposed to rain,
such as close to the door or on the
vehicle's floor.
• Install this product in an area strong
enough to bear its weight. Choose a
position where this product can be firmly
installed, and install it securely. If this
product is not securely installed, the
current location of the vehicle cannot be
displayed correctly.
• Install this product horizontally on a
surface within 0 to 30 degrees tolerance
(within 5 degrees to the left or right).
Improper installation of the unit with the
surface tilted more than these tolerances
increases the potential for errors in the
vehicle's location display, and might
otherwise cause reduced display
performance.
• When installing, to ensure proper heat
dispersal when using this unit, make sure
you leave ample space behind the rear
panel and wrap any loose cables so they
are not blocking the vents.
5 cm
Leave ample
space
5 cm
• The cords must not cover the area shown
in the figure below. This is necessary to
allow the amps and navigation
mechanism to dissipate heat.
Do not cover this area.
• The semiconductor laser will be damaged
if it overheats, so don't install this product
anywhere hot- for instance, near a heater
outlet.
Before installing this
product
1
Remove the trim ring.
Extend top and bottom of the trim ring
outwards to remove the trim ring.
Trim ring
2
Insert the supplied extraction keys
into both sides of the unit until they
click into place.
3
Pull the unit out of the holder.
Extraction key
Installation with the
holder
1
Install the holder into the dashboard.
2
Secure the mounting sleeve by using a
screwdriver to bend the metal tabs
(90°) into place.
182 mm
112 mm
Dashboard
Holder
3
Install this product into the holder.
Dashboard
4
Attach the trim ring.
Trim ring
En
9