Advertisement
Available languages
Available languages
Setting Screen Brightness
By default, the tool's screen will be set at 25%
brightness. To change the brightness level, follow
these steps.
1.
On the first screen (Figure
display the Main Menu.
2.
On the Main Menu (Figure
press
.
3.
On the Settings Menu (Figure
press
.
4.
Select the desired brightness level: 25%, 50%,
75%, or 100%.
5.
Press
to save your new setting.
Turning Off the Sound
By default, the tool will beep each time you take a
measurement. You can turn off the beeps.
1.
On the first screen (Figure
display the Main Menu.
2.
On the Main Menu (Figure
press
.
3.
On the Settings Menu (Figure
press
to display
4.
Press
to save your setting.
Changing the Unit of Measure
By default, the tool will display measurements in
inches (74
in). You can change the unit of
9/16
measure to fractional ft (6'02"
decimal ft (6.21 ft), or decimal inches (3.21 in).
1.
On the first screen (Figure
display the Main Menu.
2.
On the Main Menu (Figure
press
.
3.
On the Settings Menu (Figure
and press
.
), press
to
E 1
), select
and
E 2
), select
and
G
), press
to
E 1
), select
and
E 2
), select
and
G
.
ft/m
), meters (1.8940 m),
9/16
), press
to
E 1
), select
and
E 2
ft/m
), select
G
4.
Select the unit of measure.
• 0'00" 0/00
• 0" 0/00
• 0'00" ft
• 0.00 in
• 0.0000 m
5.
Press
to save your setting.
Choosing the Tool Position
By default, distances are measured from the bottom
of the tool to a wall or object (Figure
measure distances from a different tool location, follow
these steps.
1.
On the first screen (Figure
display the Main Menu.
2.
On the Main Menu (Figure
press
.
3.
Select the tool position.
• To measure from the top of the tool
(Figure
), select
F 1
• To measure from the tripod connection on the
tool (Figure
F 2
• To measure from a corner or another hard-to-
reach location with the endpiece flipped open
(Figure
), select
D 1
measure from the end of the endpiece.
4.
Press
to save your new setting.
Taking Measurements
Measuring Distance
1.
Point the tool's laser (Figure
or object, and not toward anyone's eyes.
2.
Press
(Figure
and display the red laser dot.
3.
Make sure the tool position setting (Figure
is correct for taking the measurement.
4.
Point the tool's laser (Figure
the wall or object whose distance you need to
measure (Figure
H 1
). To
F 3
), press
E 1
), select
E 2
.
), select
.
(Figure
) to
F 4
) toward a wall
A 1
) to turn the tool on
A 3
C 4
) toward
A 1
).
E
to
and
)
13
Advertisement
