Table of Contents
Advertisement
NOTE: In order to gain access to the hardware directly underneath the cable drum it may be
necessary to unspool the cable from the winch drum.
LUBRICATION
All moving parts in the winch are permanently lubricated with high-temperature lithium grease at the
time of assembly. Under normal conditions factory lubrication will suffice. Lubricate cable periodically
using light penetrating oil. Inspect for broken strands and replace if necessary. If the cable becomes
worn or damaged, it must be replaced.
PREPARING THE CABLE FOR INSTALLATION
Unwind the new cable by rolling it along the ground to prevent kinking. Remove old cable and
observe the manner in which it is attached to the drum flange.
MOUNTING THE CONTROL BOX
The control box can be mounted in various ways depending on the application. What follows are the
manufacturer's recommendations, which shows the steps to attach the control box to the winch
motor base.
WINCH WIRING INSTALLATION
Page
5
of 15
Advertisement
Table of Contents
