Table of Contents
Advertisement
Radio Control Specifications:
Working Voltage
Frequency
Power
Working Temperature
Maximum Control Distance
5. To commence winching operation, start vehicle engine, place transmission in neutral, maintain
engine speed at idle. Never winch with your vehicle in gear or in park, which can damage
your vehicle's transmission.
6. Never wrap the cable around an object and hook onto the cable when winching.
7. Keep hands, clothing, hair and jewelry clear of the drum area and cable when winching.
8. Never use the winch if the cable is frayed, kinked or damaged.
9. Never allow anyone to stand near the cable, or in line with the cable behind the winch while it
is under power. If the cable should slip or break, it can suddenly whip back towards the winch,
causing a hazard for anyone in the area . Always stand well to the side while winding.
10. Remove switch from 12V power port when winch is not in use.
11. Do not operate multiple winches with same frequency at the same time by remote control
within a distance of 220 feet; interference will occur among radio signals with same frequency.
12. If water enters the handheld controller, immediately remove battery and clean the circuit board
with ethyl alcohol (density required ≥98%).
13. Replace batteries in the handheld controller regularly; low voltage will affect performance.
9V–12V
433MHz
10mW
o
-4
to 140
100 ft.
Page
10
of 15
o
F
Advertisement
Table of Contents
