Table of Contents
Advertisement
www.braveproducts.com
800-350-8739
5. SAFETY NOTICE & DECALS
The "SAFETY ALERT SYMBOL" is used to call attention to items or operations that may be dangerous
to those operating or working with this equipment. These symbols can be found throughout the
manual and on the unit itself. Please read these warnings and cautions carefully.
Carefully read and follow all safety decals. Keep them in good conditions. If they become aged,
replace as required. If repainting, REPLACE ALL decals. Decals are available from your
authorized dealers. Decals are not shown to scale.
CAUTION
WHEN TOWING, ENSURE
DRAWBAR IS IN THE
MIDDLE POSITION.
201012
CAUTION
2-PERSON LIFT REQUIRED
TO POSITION MIXER HITCH
ON/OFF VEHICLE
201155
800-350-8739
IMPORTANT NOTICE
READ SAFETY DECALS CAREFULLY
WARNING
ROTATING PART HAZARD
ALWAYS STAND CLEAR OF THE DUMP HANDLE
WHEN MIXER IS IN OPERATION. ANY BINDING OF
MATERIAL BETWEEN MIXER BLADES AND THE
DRUM MAY CAUSE DRUM HANDLE TO QUICKLY
MOVE TO THE CHARGE POSITION.
201354
MBRPMM106H Rev. A.1
•
ENSURE THE VEHICLE HAS TOWING CAPACITY FOR THE WEIGHT OF THIS
MACHINE.
•
DO NOT TOW MACHINE UNLESS THE DRAW BAR IS BOLTED IN PLACE AND THE
SAFETY PIN IS SECURELY FASTENED.
•
CLOSE ENGINE FUEL CUTOFF BEFORE TOWING MIXER TO PREVENT LEAKING OIL
INTO ENGINE CRANKCASE.
•
2-PERSON LIFT PER UNIT TO POSITION MIXER ON VEHICLE.
•
SECURELY ATTACH HITCH TO TOWING VEHICLE. ENSURE USE OF SAFETY PIN
THROUGH LATCH OR HANDWHEEL FOR BALL TYPE HITCH.
SAFETY CHAIN ATTACHMENT (SEE PICTURE) MUST CROSS UNDER THE DRAW
•
BAR AND BE POSITIONED TO PREVENT THE DRAW BAR FROM DROPPING TO THE
GROUND IN THE EVENT OF HITCH FAILURE.
CONNECT LIGHTING PLUG/ELECTRIC BRAKE PLUG
•
(WHEN APPLICABLE)
201157
•
MAKE CERTAIN THAT THE WHEEL LUG NUTS AND
AXLE MOUNT HARDWARE IS TIGHTENED.
•
CHECK PRESSURE AND OVERALL CONDITION
OF TIRES.
•
TEST BREAKS (IF APPLICABLE)
201150
NOTICE
Page 8
Advertisement
Table of Contents
