www.braveproducts.com
800-350-8739
• Never service or lubricate the unit engine while running.
• After servicing the unit, restore and fasten all guards, shields, and covers to their original
positions.
• Never drain oil into the ground, into open streams, or down sewage drains.
ENGINE
See engine owner´s manual maintenance schedule.
If lost please visit
information.
DRUM
1. Wash the drum after every day's usage.
2. Pull the locking pin and tip the drum forward to drain water excess.
3. Leave mixer drum facing down to avoid rainwater, snow, dust or any other weather
particles to get inside the mixer drum when not in use.
4. Secure with locking pin before moving mixer for towing or storing.
LUBRICATION
1. Grease all fittings daily. All mixers have 6 grease fittings, 4 pillow blocks and 2 drum
trunnions. Two of the fittings are located at each end of the mixer drum on the top of
pillow blocks and trunnions.
The two remaining grease fittings are located under the engine shroud on the top of the
intermediate shaft pillow blocks.
2. Electric mixers only: oil the drive chain once a week.
11. MAINTENANCE SCHEDULE
Engine
Refer to engine operator/owner manual
Bearings
Grease
V-Belts
Check for excessive wear
Hardware
Check and tighten 1,2
Tires
Check air pressure
1. Check all hardware after the first 5 hours of use, the follow the maintenance schedule.
2. Re-torque the front leg and axle hardware after the first 50 miles traveled, and then
follow the maintenance schedule.
800-350-8739
10. SERVICE INSTRUCTIONS
https://engines.honda.com/parts-and-support/owners-manuals
Maintenance
MBRPMM106H Rev. A.1
Each
Every
Every
use
20 hours
50 hours
X
X
X
X
X
X
for more
Every
Yearly
100 hours
X
X
X
X
Page 14