Table of Contents
Advertisement
www.braveproducts.com
800-350-8739
WARNING
EXCESSIVE TOWING SPEED CAN CAUSE SERIOUS
INJURIES OR DEATH.
DO NOT EXCEED 45 MI/HR. (73 KM/HR.)
•
BE CERTAIN THAT THE WHEEL LUG NUTS AND AXLE
MOUNTING HARDWARE ARE TIGHTENED.
•
CHECK PRESSURE AND OVERALL CONDITIONS OF
TIRES.
201151
NOTICE
•
ENSURE THE VEHICLE HAS TOWING CAPACITY FOR THE WEIGHT OF
THIS MACHINE.
DO NOT TOW MACHINE UNLESS THE DRAW BAR IS BOLTED IN PLACE
•
AND THE SAFETY PIN IS SECURELY FASTENED.
•
CLOSE ENGINE FUEL CUTOFF BEFORE TOWING MIXER TO PREVENT
LEAKING OIL INTO ENGINE CRANKCASE.
•
2-PERSON LIFT PER UNIT TO POSITION MIXER ON VEHICLE.
•
SECURELY ATTACH HITCH TO TOWING VEHICLE. ENSURE USE OF
SAFETY PIN THROUGH LATCH OR HANDWHEEL FOR BALL TYPE HITCH.
•
SAFETY CHAIN ATTACHMENT (SEE PICTURE) MUST CROSS UNDER THE
DRAW BAR AND BE POSITIONED TO PREVENT THE DRAW BAR FROM
DROPPING TO THE GROUND IN THE EVENT OF HITCH FAILURE.
•
CONNECT LIGHTING PLUG/ELECTRIC BRAKE PLUG
(WHEN APPLICABLE)
•
MAKE CERTAIN THAT THE WHEEL LUG NUTS AND
AXLE MOUNT HARDWARE IS TIGHTENED.
CHECK PRESSURE AND OVERALL CONDITION
•
OF TIRES.
TEST BREAKS (IF APPLICABLE)
201150
7. BEFORE OPERATING
• REMEMBER! It is the owner´s responsibility to communicate information on the safe
use and proper operation of this unit to the operators.
• Before operating, review SAFETY PRECAUTIONS listed on page 7 of this manual.
• Familiarize yourself with the operation of the unit and confirm that all controls function
properly BEFORE starting engine.
• Locate the kill switch and assure you know how to STOP the unit.
• Make sure hands, feet, and clothing are at a safe distance from any moveable parts prior
to starting.
• Shrouds and grids are provided to protect the operator or structures in close proximity
to rotating hot engine parts. It is the RESPONSIBILITY OF THE OPERATOR to see that
they are properly in place.
• OIL LEVEL - Check the oil level in the engine. For more information see "Lubrication"
under the engine "Owner's Manual" the "Maintenance" section of this manual.
800-350-8739
CAUTION
2-PERSON LIFT REQUIRED TO
POSITION
MIXER
ON/OFF VEHICLE
201155
MBRPMM106H Rev. A.1
ROTATING PART HAZARD
TO PREVENT SERIOUS INJURY OR DEATH ROTATING PARTS:
1. INSTALL, CLOSE AND SECURE ALL GUARDS, SHIELDS AND
HOODS BEFORE OPERATING.
2. DO NOT PLACE HANDS IN DRUM UNLESS THE MOTOR
OR ENGINE IS OFF AND THE POWER CORD UNPLUGGED
OR THE KILL SWITCH ACTIVATED.
KEEP HANDS, FEET, HAIR AND LOOSE CLOTHES AWAY
3.
FROM MOVING PARTS.
201003
WARNING
ROTATING PART HAZARD
ALWAYS STAND CLEAR OF THE DUMP HANDLE
WHEN MIXER IS IN OPERATION. ANY BINDING OF
MATERIAL BETWEEN MIXER BLADES AND THE
DRUM MAY CAUSE DRUM HANDLE TO QUICKLY
MOVE TO THE CHARGE POSITION.
HITCH
WHEN
DRAWBAR IS IN THE MIDDLE
POSITION.
WARNING
KEEP AWAY
201157
CAUTION
TOWING,
ENSURE
201012
Page 11
Advertisement
Table of Contents
