Toshiba MML-AP0074NH1-E Service Manual page 119

No. Part name
Electrical parts 1) Remove screw for Terminal cover (UP).
②
Box assembly
2) Remove screw for LED base.
(E-box)
NOTE
Take off control wire and wired remote
controller wire before it removes E-box
cover. Otherwise, defective control might
be caused.
3) Remove screw for E-box cover.
4) Remove damper motor connector, flow
selector connector and TA sensor from
pipe cover (F).
5) Take off damper motor connector.
6) Remove screw for pipe cover (F).
(3 pcs)
7) Remove screw for drain guide (UP).
Procedure
118
Remarks
Terminal cover (UP)
Terminal cover
3) Screw for Terminal cover
Drain guide (UP)
7) Screw for
drain guide (UP)
6) Screw for
pipe cover (F)
(3pcs)
Pipe cover (F)
1) Screw for Terminal cover (UP)
4) Damper
motor connector
4) TA sensor
4) Flow selector
connector