Toshiba MML-AP0074NH1-E Service Manual page 105

Wiring connection
How to connect the power supply wiring and control wiring
REQUIREMENT
Connect the control wire after connecting the power supply wire for this model.
1) How to connect the power supply wiring
1. Removing the front panel.
2. Remove the terminal cover and cord clamp.
3. Take a power supply wire and control wire (according to the local rule) into the pipe hole on the hole.
4. Take the power supply wire out of the cable slot on the rear panel so that it produces about 430 mm form the front.
5. Insert the power supply wire fully into the terminal block and secure it tightly with screws.
Tighten torque: 1.2 N/m (0.12 kgf/m)
6. Clamp the power supply wire with the cord clamp.
7. Attach the terminal cover with a screw
CAUTION
• Be sure to refer to the wiring diagram attached inside the front panel.
• Check local electrical cords and also any specifi c wiring instructions and limitations.
• Do not catch the control wire when installing the clamp base.
Terminal cover (UP)
Power supply
terminal block
Terminal cover
Screw
Screw
L N
Earth line
<Stripping length of the
power supply wire>
Screw
Terminal block for control/wired
remote controller wiring
, , ,
R(L) S(N)
Cord clamp
Power supply
terminal block
Earth wire for
Cord clamp
power supply
wire
Earth screw Power supply
wire
<Connecting power supply wire>
2) How to connect the control wiring
1. Take the control wire out of the cable slot on the rear panel so that it produces about 600 mm form the front.
2. Remove the terminal cover (UP)
3. Remove the LED BASE
4. Insert the control wire fully into the control/Wired remote controller terminal block
tightly with screws.
5. Clamp the control wire with the cable clamp.
6. Pass the banding band through the hole of the mount base.
7. Band the control wire and the remote controller wire in the banding band.
8. Attach the LED base, terminal cover and front panel.
EN
FR
DE
IT
ES
PT
NL
GR
Control wire
RU
TR
CS
LV
SK
SI
LED base
Hook for fi x LED base
U1 U2 A B
Shield wire
Remote control wire
<Stripping length of the control wire>
Screw
Control wire
Shield wire for
Display base
earth wire
Slot for fi x LED base
Earth screw for
shield wire
<Connecting control wire and remote controller>
<How to remove LED base>
, , , and secure it
Terminal block for control/wired
remote controller wiring
Remote controller wire
Cable
clamp