Table of Contents
Advertisement
Operation Manual / TPL69-A10 / -A30 ... TPL77-A10 / -A30
7 Removal and installation / 7.2 Removing the turbocharger
7.2 Removing the turbocharger
© Copyright 2020 . All rights reserved.
Disconnect all gas, air and oil pipes in accordance with the engineb-
u
uilder's instructions.
CAUTION
Oil orifices
There is an orifice for adjusting the oil pressure in each of the two oil
supply pipes of the bearing casing. When the cartridge group, the bear-
ing casing or the turbocharger-is being fitted to the engine, it must be
ensured that the orifices specified for the turbocharger are installed in
both oil supply pipes.
Check that the oil orifices have been correctly installed.
u
Unplug the cable connector on the speed sensor.
u
Remove the insulation at the suspension ribs.
u
Version with compressor wheel cooling system
Dismantle air supply line.
u
Inspect the lifting gear.
u
HZTL2481_EN
Rev.D
March 2020
Advertisement
Table of Contents
