Table of Contents
Advertisement
Preparation
2
Installing / Removing the Base Stand
The LCD display is very fragile, and must be protected at all times when installing and removing the base stand. Be sure that
no hard or sharp object, or anything that could scratch or damage the LCD display, comes into contact with it. DO NOT exert
pressure on the front of the TV at any time because the screen could crack.
Attaching the Neck
1. Ensure the TV is switched off and not connected to the mains power supply.
2. Keep the protective bag on the TV to protect it. You may need to cut the protective bag before fitting the stand.
3. Make sure you have some help, this requires 2 people. Lay the TV down on a flat surface ideally on the edge of a table so
the base of the TV slightly overhangs the edge of the table, with the back side facing up. Please make sure a soft cushioned
material (such as a dry bath towel or thick piece of foam) is placed beneath the screen. Be very careful not to knock the edges
of the TV, the screen is very fragile.
4. Attach the neck using 4 x screws (A).
If you don't have a table big enough, you can use the TV box. Lie the box flat, make sure you place the polystyrene back in
the box first to give the box some rigidity and strength.
Fitting the Base
5. Attach the base using 4 x screws (B). Be careful when attaching the base its heavy.
8
JVC 65' LED Smart 4K HDR TV LT-65C898 Manual.indd 8
Protective
Cushioned
Bag
material
4 x
Screw (A)
Table
4 x
Screw (B)
18/02/2019 10:03
Advertisement
Table of Contents
