Table of Contents
Advertisement
Installing / Removing the Base Stand
• The LCD display is very fragile, and must be protected at all times when installing and removing the base stand. Be sure
that no hard or sharp object, or anything that could scratch or damage the LCD display, comes into contact with it. DO
NOT exert pressure on the front of the TV at any time because the screen could crack.
• It is recommended that two people take part in the base installation.
1. Disconnect all cables connected to the TV.
2. Lay the TV down on a flat surface with the back side facing up, and ideally at the edge of a table so that the base of the TV
slightly overhangs on it. Please make sure a soft cushioned material (such as a towel or thick piece of foam) is placed beneath
the screen. Leave the protective bag on your TV until you have fully attached the TV stand.
Installing the Base Stand
To install the TV stand, attach the TV stand to the TV. Align the screw holes and joggle joint, then secure with a screw driver (not
included) using the screws provided.
The screw holes will only align if the front of the base stand is at the front of the TV.
TV Stand
Support
(Right)
• Please read this instruction manual carefully while setting up your TV.
• If you require additional assistance:
For UK, please call our UK Call Centre on 0344 561 1234.
For Ireland, please call our Ireland Call Center on 1 890 818 575.
Screw x 2
TV Stand
Support
(Left)
Screw x 2
Preparation
2
9
Advertisement
Table of Contents
