Table of Contents
Advertisement
11
APPLICABLE CONTROLS
A wired remote controller is necessary for this function. This function cannot be operate with a wireless
remote controller.
REQUIREMENT
• When you use this air conditioner for the
first time, it takes approx. 5 minutes until the
remote controller becomes available after
power-on. This is normal.
<When power is turned on for the first
time after installation>
It takes approx. 5 minutes until the remote
controller becomes available.
Power
"SETTING"
on
flashes
<When power is turned on for the second
(or later) time>
It takes approx. 1 minute until the remote
controller becomes available.
Power
"SETTING"
on
flashes
• Normal settings were made when the indoor
unit was shipped from factory.
Change the indoor unit settings as required.
• Use the wired remote controller to change
the settings.
* The settings cannot be changed using
the wireless remote controller, sub remote
controller, or remote-controller less system
(for central remote controller only).
Therefore, install the wired remote
controller to change the settings.
29-EN
Approx. 5 minutes
"SETTING"
Remote
goes out
controller is
available
Approx. 1 minutes
"SETTING"
Remote
goes out
controller is
available
Basic procedure for changing
settings
Change the settings while the air conditioner is not
working.
(Stop the air conditioner before making settings.)
Set only the CODE No. shown in the following
table: Do NOT set any other CODE No.
If a CODE No. not listed is set, it may not be
possible to operate the air conditioner or other
trouble with the product may result.
* The displays appearing during the setting
process differ from the ones for previous
remote controllers (AMT31E). (there are more
CODE No.)
4
6
1
5
1
Push
button and TEMP.
simultaneously for 4 seconds or more.
After a while, the display flashes as shown in
the figure.
Confirm that the CODE No. is [01].
• If the CODE No. is not [01], push
to erase the display content, and repeat the
procedure from the beginning.
(No operation of the remote controller is
accepted for a while after
pushed.)
(* Display content varies with the
indoor unit model.)
‒ 29 ‒
Installation Manual
CAUTION
1
3
2
button
button
button is
Advertisement
Table of Contents
