Changing A Wiper Blade; Recovering The Vehicle - PEUGEOT 3008 HYbrif4 Handbook

CHANGING A WIPER BLADE

Before removing a front wiper
blade
Within one minute after switching off
the ignition, operate the wiper stalk
to position the wiper blades verti-
cally on the windscreen.
Removing
Raise the corresponding wiper arm.
Unclip the wiper blade and remove it.
Fitting
Put the corresponding new wiper
blade in place and clip it.
Fold down the wiper arm carefully.
After fitting a front wiper blade
Switch on the ignition.
Operate the wiper stalk again to
park the wiper blades.
190
RECOVERING THE VEHICLE ON
A FLAT-BED
Procedure for having your vehicle re-
covered on a fl at bed lorry or trailer.
Always recover the vehicle
on a fl at bed lorry or trailer.
Never tow the vehicle with the
four wheels on the ground (or the
front or rear wheels only), you risk
damaging the transmission.
Place the gear lever in position N and
switch off the engine ( Ready lamp off).
Access to the tools
The towing eye is installed in the boot
under the fl oor. The towing eye is used
only to pull the vehicle onto the recovery
vehicle, not for towing the vehicle.
To gain access to it:
open the boot,
raise the fl oor,
remove the towing eye from the holder.
From the front
On the front bumper, unclip the cover
by pressing at the bottom.
Screw the towing eye in fully.
From the rear
On the rear bumper, unclip the cov-
er by pressing at the bottom.
Screw the towing eye in fully.
Switch on the hazard warning lamps
on the recovered vehicle.