First Assembly - Trikke DEFENDER Owner's Manual

FIRST ASSEMBLY

1) Remove the unit from the packing box
2) Unfold the frame, lock the folding levers.
3) Attach handlebar, align with front wheel, tight handlebar clamp bolts.
4) Install the foam protector
5) Locate and connect the 4 wires of the front lights and horn. Keep the wires neat.
6) Install battery – a) make sure the key-lock pin is retracted (counterclockwise). b) identify
front and back side of the battery c) place the battery on the tray tilted to the back. d)
push the battery forward against the lock all the way and turn the key clockwise to lock.
You may remove the key from the lock and place in a safe place.
7) Check/calibrate tires pressure. Use a floor pump with a reliable gauge with a threaded
connector. Front 50psi, Rear 65psi.
FOLDING
1) Retract the lock knob on each folding mechanism
2) Pull the knob up to unlock the tensioners (while leaning the vehicle to the opposite
side)
3) Fold the frame
4) Screw the knobs into the hole in order to lock the frame folded. This is imperative
for handling and transport.
UNFOLDING
1) Retract the lock knob on each folding mechanism (about 1cm)
2) Unfold the frame
3) Press down the tensioners (while leaning the vehicle to the opposite side) until it
snaps into locked position
4) Screw the knobs in until it locks. These will be on top of the tensioners as a safety
pin.
(watch assembly video)
DEFENDER Owner's manual
Page 4