Advertisement
CIP Training 8300
Misfeed
• Multiple paper misfeed locations may be indicated at the same time. When this happens, check
all the areas indicated.
• If there is no misfed paper in the area you check first, see the other areas that are indicated.
• If coated paper frequently becomes jammed and causes "U" to appear, contact your service
representative.
• If a paper misfeed occurs in Rb1 - Rb5, check whether any paper has been output on top of the
paper press of the finisher shift tray. If there is paper on top of the paper press, remove the
paper, and then remove the misfed paper from inside the finisher.
• When paper cannot be transferred to the post-processing side by turning the knob D1 as
instructed on the screen, see the position of the letter in the figure and turn the knob D1 in
reverse direction (clockwise) to send the paper back to the drawer unit, and then remove the
paper.
• After C is displayed and the drawer unit is pulled out to remove the jammed paper, check that
there is no toner searing on the location indicated in the figure. If toner smear is left, wipe off
the toner with a clean and dry cloth.
• If a paper jam occurs when using banner paper of 700.1 mm - 1260 mm (27.56 - 49.61 inches) in
length, open all guide plates along the feeding path in which the paper jam occurred and
remove the jammed paper.
Series
Advertisement
