Assembling Sc-J2S(B) J4Kt02K/06K - Mitsubishi Electric MELSERVO-J2S Series Manual

３.３.２ Assembling SC-J2S(B) J4KT02K/06K
（１）Preparing to Assemble Renewal Kit
Remove the terminal block from the TE1 bracket, which was mounted at the time of shipment.
Note The terminal block you need to remove is different depending on whether a battery is
used or not.
Follow the instructions below to remove one.
①In the Case of an Incremental System
(Where Servo Amplifier Battery Option "MR-BAT6V1SET" Is Not Used)
・Remove Terminal Block U/V/W only.
②In the Case of an Absolute Position Detection System
(Where Servo Amplifier Battery Option "MR-BAT6V1SET" Is Used)
・Remove Terminal block L1/L2/L3 only.
Terminal Block U/V/W
TE1 Bracket
①When a battery is not used
(in the case of an incremental system)
Note Cables and other components in Renewal Kit are not illustrated here for you to easily see how the
components are assembled.
②When a battery is used
(in the case of an absolute position detection
３-３
3 － 3
Terminal Block L1/L2/L3
TE1 Bracket
system)