Haier AS25S2SN1FA-NRC Operation Manual page 8

Operation
1
TIMER
TURBO
Unit will start running to reach the
temp. setting on LCD.
SELF CLEAN
2
AN Operation AN Operation
changes as follows:
Unit will run at selected fan speed.
button.
pressed, temp. setting
increases 1 ºC.
pressed, temp. setting
decreases 1 ºC.
TIMER
TURBO
SELF CLEAN
1
SELF CLEAN
Functional description
the purpose of this function is to clean the evaporator.
Entry and exit
Press SELF CLEAN button to enter this function, then
it will display "CL" on the panel of the indoor unit and also
on the remote controller. Maximum running time not more
than 25 minutes, this function will exit automatically with
the " Pi " sound twice, then the unit return to original state.
Under operation process of SELF CLEAN, press the button
repeatedly is invalid and cannot exit, please press the
"power" button or swift to other mode to exit.
Note:
1.This function is invalid in timer / sleep mode.
2.After this mode starts, the air volume may reduce or
even have no airflow,or even cold airflow blowing.
3.It is normal if the unit make some sound like expand with
heat and contract with cold
4. The "CL" display time may last differently on the remote
controller and panel.
5.If the outside ambient temperature below zero, error
code "F25 "may be occurred during self-cleaning operation ,
which is normal protection, please turn off the power
and to restart after 10 seconds .
6.The best condition to run this mode: the temperature is
20 ~27 and the humidity is 35 ~60
the temperature is 25 ~38
door.
7.It is hard to frost if the air is too dry(humidity 20%). and
if the humidity is too high(humidity 70%).the condensate
water may increase, which may move away some frost.
5
TURBO TURBO
SELF CLEAN
:
in the door,
cooling season out the
4