Table of Contents
Advertisement
Menu Items
COLOR ADJUSTMENT
GAMMA
Selects the gamma. USER sets the gamma to the sent value (see page 41).
(In PIP mode, the main side setting is reflected in the image.)
FLESH TONE (AV input)
Adjust the hue control.
When FLESH TONE is set to LOW or HIGH, C.M.S.-HUE/-SATURATION/-VALUE cannot be set.
C.M.S.-HUE (AV input)
Adjusts color tone with 6 colors of R (red), Y (yellow), G (green), C (cyan), B (blue), and M (magenta).
C.M.S.-SATURATION (AV input)
Adjusts color vividness with 6 colors of R (red), Y (yellow), G (green), C (cyan), B (blue), and M (magenta).
C.M.S.-VALUE (AV input)
Adjusts color brightness with 6 colors of R (red), Y (yellow), G (green), C (cyan), B (blue), and M (magenta).
ADVANCED
AUTO (D-SUB[RGB]/DVI-I (analog))
The ANALOG GAIN and ANALOG OFFSET are automatically adjusted.
ENTER
Pressing
performs adjustment.
ANALOG GAIN (D-SUB[RGB]/DVI-I (analog))
Adjusts the bright portions of the video input signal.
ANALOG OFFSET (D-SUB[RGB]/DVI-I (analog))
Adjusts the dark portions of the video input signal.
3D-NR (AV input)
Reduce the noise of playback images on video.
Setting a higher level reduces more noise. However, it may cause blurring on an image.
MPEG-NR (AV input)
Reduce block noise caused by digital compression.
3D-Y/C (D-SUB[VIDEO])
Specify whether to perform 3-dimension Y/C separation.
If dot interference or cross-color is occurring in fast-motion scenes, selecting "OFF" may improve the image quality.
RGB INPUT RANGE (DVI-I/HDMI[PC]/HDMI[AV]/D-SUB[RGB]/DisplayPort)
Sets the RGB input signal range. When using HDMI or DisplayPort set to AUTO, the RGB input signal is detected
automatically. Use AUTO normally.
If the RGB input signal range cannot be set appropriately even when using AUTO, set according to the image. When the
setting is different, images will be displayed with washed out blacks and compressed gradients.
ACTIVE CONTRAST (AV input)
Automatically adjusts the contrast according to the image.
(In PIP mode, the main side setting is reflected in the image.)
The adjustment operation may not be smooth depending on the image. In this case select OFF.
DISPLAY COLOR PATTERN
Displays a color pattern. Can be displayed while the menu screen is displayed, so you can refer to the pattern while adjusting
the image.
OFF ...............No pattern display.
WHITE ...........White single color pattern display.
RED...............Red single color pattern display.
GREEN .........Green single color pattern display.
BLUE .............Blue single color pattern display.
USER ............Red/green/blue mixed color pattern display. When USER is selected, set each color's level.
UNIFORMITY
Sets the LCD panel's discoloration correction level.
OFF ............................... Discoloration will not be corrected.
MODE1 to MODE3 ........ The effect of the discoloration correction will increase from MODE1<MODE2<MODE3.
RESET
Resets the values of the PICTURE menu items to the factory preset values.
Select "ON" and then press
28
E
However, brightness and contrast will also decrease from MODE1<MODE2<MODE3.
ENTER
.
Advertisement
Table of Contents
